Full magnetic mapping ITF 18W and tuned for O4

this time, for all locations the small coil is alighned with the markers 

opened door TCS room about 8:30 UTC

monitor INF_TCSroom_TE

glitch at 8:40 UTC

TCS room

with Ilaria: point absorber setup

around 8:50 - switched off 4 devices: 
point absorbe NI power supply 
point absorber NI pre-amp
point absorber pico-motors driver, 
thorlab module tri-axis piezo controller (piezo driver laser CO2)


magnetic injections 

coil current monitor ENV_TCS_MAG_COIL_CURR_MON
DAC channel ENV_NOISE_TCSroom

glitch at 8:59:40 (to be checked)
glitch at 9:04:45

9:16 Fabio goes to LowNoise3_SQZ (request by Fiodor)

TCS_PR_CHROCC_V_OUT is decreasing ..... rom 2.87 to 2.85 V, is it a Problem? Ilaria contacted, then Piernicola

glitch (small) at 9:19:30
glitch at 9:29:27
glitch at 9:29:59
glitch 9:53:37
glitch 10:18:20
...
glitch 11:31
glitch 11:56:46


WI tower

coil axis EW
sweep 2.5V, 1 - 600 Hz, 300s
start 9:41:13
stop 9:48:37

we observe some excess noise fluctuating below 40Hz ... it is due to us! (amplifier produces a broadband noise (altrady noticed)

coil axis NS
start 9:50:27
stop 9:56:24

coil axis VERT
start 9:58:01
stop 10.04.53

NI tower

sweep 5V, 1-600Hz, 300s
coil axis EW

start 10:13:12
stop 10:20:29

coil axis NS
start 10:21:22
stop 10:28:04

coil axis VERT
start 10:29:40
stop 10:35:06

BS tower

sweep 5V, 1-600Hz, 300s
coil axis EW  (we see an effect!)
start 10;36:34
stop 10:44:17

coil axis NS
start 10:45:01
stop 10:50:22

coil axis VERT
start 10:51:30
stop 10:57:19

Left TCS room door open

EEroom

monitor ENV_IB_MAG_COIL_CURR_MON

SIB1 tower (West side)

sweep 1-600Hz, 5V, 300s

coil axis EW  
start 11:13:47 (resonance peaks are more evident here) 
stop 11:19:35

coil axis NS
start 11:20:24
stop 11:27;06

coil axis VERT
start 11:28:25
stop 11:33:46


DET EEroom

SDB1 tower (East side)

sweep 1-600Hz, 5V, 300s

coil axis EW
start 11:51:24 (resonances peaks are evident here)
stop 11:56:46

coil axis NS
start 11:58:27 (resonances are well evident aslo here)
stop 12:04:14

12:04:45 unlock .... NE suspension unlocked, seems and ENV noise (ACC) some seconds before

coil axis VERT
start 14:25:17
stop 14:31:25

approx. 13:30 UTC - phyiscally disconnected all cables from point absorber device on NI tower base

13:57 new lock - low noise 3

14:22:40 glitch (!)

WE building
ENV_WEB_MAG_SMALL_COIL_CURR_MON
ENV_NOISE_WEB

14:48:19 ITF unlock because of NE: same kind of noise in ENV_ACC sensors

further unlocks associated to NEB noise

We stop here with injections and go to NEB to inspect 


Test Acoustic colored injections in CEB 

AcousticInjectionsCEB
started at 16:42:41


























%